[Grml] grml install on SD card

T o n g mlist4suntong at yahoo.com
Wed Jul 29 00:30:36 CEST 2009

On Fri, 24 Jul 2009 16:41:21 -0400, Sean Kennedy wrote:

> I have noticed that grml2hd (I use it to put grml onto a usb key) sets
> up grub (I know grub so I always chose to install it over lilo) to boot
> from the second hard drive.
> i.e. (hd1,0)
> (that is likely where it was was when the live version was run) But when
> you want to boot it, the hardware has detected it first and put it in
> the first position (hd0,0).
> If this is the case for you, you will have to muck about in the boot
> manager to resolve the problem.

If it is the case, then the best solution is 

Boot by UUID or disk label


Stable root device (AKA UUID)


Tong (remove underscore(s) to reply)

More information about the Grml mailing list